Ferris 5901849, Руководство оператора

Страница: 22 / 60

Not for
Reproduction
22 ferrismowers.com
20
To turn in place, “Zero Turn,” gradually move one ground
speed control lever forward from neutral and one lever back
from neutral simultaneously. Repeat several times.
NOTE: Changing the amount each lever is pulled—forward or
back, changes the “pivot point” you turn on.
Advanced Driving
Executing an End-Of-Row Zero Turn
21
Your Zero Turn Rider’s unique ability to turn in place allows
you to turn around at the end of a cutting row rather than
having to stop and Y-turn before starting a new row.
For example, to execute a left end-of row zero turn:
1. Slow down at the end of the row.
2. Move the RIGHT ground speed control lever forward
slightly while moving the LEFT ground speed control lever
back to center and then slightly back from center.
3. Begin mowing forward again.
This technique turns the rider LEFT and slightly overlaps
the row just cut —eliminating the need to back up and re-cut
missed grass.
As you become more familiar and experienced with operating
the Zero Turn rider, you will learn more maneuvers that will
make your mowing time easier and more enjoyable.
Remember, the more you practice, the better your control
of the Zero Turn will be!
Mowing
1. Engage the parking brake. Make sure that the PTO
switch is disengaged, the ground speed control levers
are locked in the NEUTRAL position and the operator is
sitting in the seat.
2. Start the engine. See Starting the Engine .
3. Set the mower deck cutting height.
4. Engage the PTO by pulling up on the PTO switch. The
engine speed will automatically adjust to IDLE before
engaging the PTO.
5. Press the MAX button on the digital display panel to set
the engine throttle speed to the maximum throttle setting
and beginning mowing.
6. When finished, press the IDLE button on the digital
display panel to set the engine throttle to the idle throttle
setting and then push the PTO switch down to shut off the
PTO.
7. Stop the engine. See Stopping the Rider .
Mowing Recommendations
Several factors can affect how well your machine cuts grass,
Following proper mowing recommendations can improve the
performance and life of your machine.
Height of Grass
Often cutting height is a matter of personal preference.
Typically, you should mow the grass when it is between three
and five inches high. The proper cutting height range for
a specific lawn will depend upon several factors, including
the type of grass, the amount of rainfall, the prevailing
temperature, and the lawn’s overall condition.
Cutting the grass too short causes weak, thin grass plants,
which are easily damaged by dry periods and pests. Cutting
too short is often more damaging than allowing the grass to
be slightly higher.
Letting grass grow a bit longer—especially when it is hot and
dry—reduces heat build-up, preserves needed moisture and
protects the grass from heat damage and other problems.
However, allowing grass to grow too high can cause thin turf
and additional problems.
Cutting off too much at one time shocks the plant’s growth
system and weakens the grass plants. A good rule of thumb
is the 1/3 rule: to cut no more than one third of the grass
height, and never more than 1 inch at a time.