Not for
Reproduction
42
2.
Wedge a wooden block (D) between the mower blade and
the mower deck housing to keep the mower blade from
turning and torque the blade mounting bolt to 120 ft. lbs
(163 Nm).
Cutting Height Adjustment
The cutting height is adjustable between 1-3/4" (4,5 cm) and 5"
(12,7 cm) in 1/4" (0,64 cm) increments. Figure 43 depicts the
cut height plate and the cut height decal for the unit. This figure
is intended to help you better understand the available cutting
heights for this unit.
43
To set the cutting height at 1-3/4” (4,5 cm):
1.
Pull the deck lift lever (A, Figure 44) back towards the
operator position until it locks into the 5" (12,7 cm)
TRANSPORT position.
44
2.
Remove the cutting height adjustment pin (B) from the hole
that it is installed in and put it in the storage location hole
(A, Figure 43).
3.
Pull the deck lift lever back towards the operator position
and depress the deck lift release button (C, Figure 44) to
release the transport position lock.
4.
Push the deck lift lever forward until it contacts the stationary
pin in the 1-3/4" (4,5 cm) hole.
33
Содержание 5901465
Страница 1: ...N o t f o r R e p r o d u c t i o n...
Страница 46: ...N o t f o r R e p r o d u c t i o n Notes...
Страница 47: ...N o t f o r R e p r o d u c t i o n Notes...
Страница 48: ...N o t f o r R e p r o d u c t i o n...
