Not for
Reproduction
To set the cutting height in the range of 2” (5,08 cm) and
4-3/4” (12,1 cm):
1.
Pull the deck lift lever back towards the operator position
until it locks into the 5" (12,7 cm) TRANSPORT position.
2.
Place the cutting height adjustment pin in the desired cutting
height hole.
3.
Pull the deck lift lever back towards the operator position
and depress the deck lift release button to release the
transport position lock.
4.
Push the deck lift lever forward until it contacts the cutting
height adjustment pin.
To set the cutting height at 5" (12,7 cm):
1.
Pull the deck lift lever back towards the operator position
until it locks into the 5" (12,7 cm) TRANSPORT position.
2.
Place the cutting height adjustment pin in any open hole.
The deck lift lock latch (D) holds the mower deck at the 5"
(12,7 cm) position while cutting.
Note: Make sure that the cutting height adjustment pin is inserted
into the holes in both upper and lower plates of the pin box (E).
Neutral Adjustment
The neutral system for this mower is a function of the transaxles.
1.
Drive the machine to a flat, level surface. Engage the
parking brake and disengage the PTO.
2.
Without touching the forward speed control levers disengage
the parking brake. If the unit moves, the neutral systems
on the transaxles are not correctly adjusted. See your
dealer.
Neutral Lockout and Tracking Adjustment
Before making adjustments to the neutral lockout or the
unit's tracking, be sure to check the following:
• Drive tires are properly inflated.
• Caster tires are greased and turn freely.
• All controls are free from damage and operate freely.
• Machine is at full operating temperature.
• Make sure that the machine is in NEUTRAL when the
ground speed control levers are released per the procedure
detailed in
Neutral Adjustment.
Positioning the Parking Brake Handle
1.
Park the machine on a flat level surface such as a concrete
floor. Disengage the PTO, engage the parking brake, turn
the ignition switch to OFF, and remove the ignition key.
2.
Chock the front wheels of the unit to prevent movement and
disengage the parking brake.
3.
Engage the parking brake by pulling the parking brake lever
(A, Figure 45) up and back while moving both ground speed
control levers forward back and forth, so that the neutral
lockouts will engage the ground speed control levers as the
parking brake is being engaged.
45
4.
With the parking brake engaged observe the flat edge of
the parking brake lever (B) in relation to the front of the dash
panel (C). The front edge of the parking brake lever should
be parallel to the front of the dash panel.
5.
To adjust the position of the parking brake lever: Locate the
threaded linkage rod (A, Figure 46) that connects the
parking brake lever to the neutral lockout shaft. Loosen the
two jam nuts (B) and turn the rod (C) until the flat edge of
the parking brake lever is parallel to the front of the dash
panel.
46
6.
Tighten the jam nuts.
34
Содержание 5901465
Страница 1: ...N o t f o r R e p r o d u c t i o n...
Страница 46: ...N o t f o r R e p r o d u c t i o n Notes...
Страница 47: ...N o t f o r R e p r o d u c t i o n Notes...
Страница 48: ...N o t f o r R e p r o d u c t i o n...
