Ferris 5901465, Руководство оператора

Страница: 28 / 48

Not for
Reproduction
29
Fuse Location and Identification
Serial Number Range 2017576822 and Below:
The electrical system for this unit is equipped with a replaceable
fuse. See the chart below for the circuit, amperage, and
approximate location of the fuse.
Approximate
Location
Amperage Circuit
Left hand side of control
tower 15 amp PTO Clutch
Serial Number Range 2017576823 and Above:
The electrical system for this unit is equipped with two
replaceable fuses. See the chart below for the circuit, amperage,
and approximate location of the fuses.
Approximate
Location
Amperage Circuit
Mounted by the battery
box on the right hand
side of the machine. 20 amp Main
Mounted under the
control panel on the right
hand side of the machine 15 amp PTO Clutch
Check / Fill Transmission Oil Level
Oil Type: SAE 20W-50 motor oil
This unit is equipped with two transmission oil tanks (A, Figure
30). One transmission oil tank only supplies oil to one
transmission. The level of oil in both transmission tanks must
be checked, and if necessary, filled.
30
1. Locate the transmission oil tanks. The transmission oil tanks
are located on the right side of the engine between the
engine and the battery box.
2. Check the oil level when the unit is cold. The oil should be
up to the “FULL COLD” mark (B) on the transmission oil
tanks. If the oil is below this level, proceed to step #3.
3. Before removing the tank cap (C), make sure that the area
around the tank caps and fill neck of the tank is free of dust,
dirt, and other debris. Remove the tank caps.
4. Add oil up to the “FULL COLD” mark.
5. Re-install the tank caps.
6. After adding oil to the tanks, it may be necessary to purge
air from the hydraulic system. If the unit is not driving
properly perform the
Purging the Air from the Hydraulic
System procedure.
Transmission Oil Filter Change
Change Interval: Every 400 Hours or Yearly (Initial hydraulic
oil and filter change after first 100 hours of operation)
Replacement Filter Number: 5101026X1
Note: Removing the oil filter from the transaxle will drain the oil
tank. Have a suitable container ready to catch any spilled oil.
The manufacturer recommends that this be a dealer-only service
item.
1. Locate the transmission oil filters (A, Figure 31) underneath
the rear of the machine on the transmissions.
28 ferrismowers.com