Ferris 5901465, Руководство оператора

Страница: 15 / 48

Not for
Reproduction
Choke: Close the choke for cold starting. Open the choke
once the engine starts. A warm engine may not require choking.
Pull the knob UP to close the choke. Push the knob DOWN to
open the choke.
Throttle Control Rocker Switch: Pressing the throttle control
rocker switch forward will increase the throttle position. Pressing
the throttle control rocker switch backwards will decrease the
throttle position. Always operate at FULL throttle when mowing.
Fast throttle speed.
Slow throttle speed.
Operation
Before First Time Operation
• Be sure to read all information in the Operator Safety and
Operation sections before attempting to operate this unit.
• Become familiar with all of the controls and how to stop the
unit.
• Drive in an open area without mowing to become
accustomed to the unit.
WARNING
• Never operate on slopes greater than 17°.
• Select slow ground speed before driving onto a slope.
Use extra caution when operating on slopes with any
collection accessories attached to the unit.
• Mow across the face of slopes, not up and down, use
caution when changing direction on slopes and do NOT
start or stop on a slope.
WARNING
• Never allow passengers to ride on the unit.
• Before leaving the operator’s platform for any reason,
engage the parking brake, disengage the PTO, stop the
engine, and remove the key.
• To reduce fire hazard, keep the engine, unit, and mower
deck free of grass, leaves, and excess grease. Do NOT
stop or park unit over dry leaves, grass, or combustible
materials.
• Fuel is highly flammable and must be handled with care.
Never fill the tank when the engine is still hot from recent
operation. Do NOT allow open flame, smoking, or matches
in the area. Avoid over-filling and wipe up any spills.
WARNING
Do NOT load this zero-turning mower on a trailer or truck
using two separate ramps. Only use a single ramp that is at
least one foot wider than the width of the rear wheels of this
unit. This unit has a zero turning radius and the rear wheels
could fall off the ramps, or the rider could tip over injuring the
operator or bystanders.
Checks Before Starting
• Check that the crankcase is filled to the full mark on the
crankcase oil dipstick. If necessary, add oil through the
engine oil fill. See the engine operator’s manual for
instructions, the location of the engine oil fill and oil dipstick,
and oil recommendations.
• Make sure all nuts, bolts, screws and pins are in place and
tight.
• Fill the fuel tank with fresh fuel. Refer to engine manual for
fuel recommendations.
• Check the hydraulic oil level.
Starting the Engine - Carbureted Models
WARNING
Read the operator's manual before attempting to operate
this unit.
• If you do not understand how a specific control functions,
or have not yet thoroughly read the Features and Controls
section, do so now.
• Do NOT attempt to operate the unit without first becoming
familiar with the location and function of all controls.
1. While standing on the operator's platform, engage the
parking brake, make sure that the PTO switch is
disengaged, and that the ground speed control levers are
in the NEUTRAL position.
2. A warm engine may not require choking. Set the engine
throttle control to FAST throttle position. Then fully close
the choke by pulling the knob OUT fully.
3. Insert the key into the ignition switch and turn it to START.
4. After the engine starts, gradually open the choke (push
knob down fully). Reduce to half throttle speed and allow
engine to warm.
Warm up the engine by running it for atleast
15