Ferris 5901465, Руководство оператора

Страница: 13 / 48

Not for
Reproduction
To adjust the position of the Maximum Forward Speed Bar pull
the T-handle knob (D) out to release the maximum forward
speed bar, position the Maximum Forward Speed Bar in the
desired location, and then release the T-handle knob. Make
sure that the T-handle knob locks the maximum forward speed
bar into place.
You should only adjust the position of the Maximum
Forward Speed Bar after you have stopped all movement
of the unit.
Ground Speed Control Levers: These levers control the
ground speed of the unit. The left lever (B, Figure 6) controls
the left rear drive wheel and the right lever controls (C) the right
drive wheel.
FORWARD
NEUTRAL
REVERSE
Moving a lever forward increases the FORWARD speed of the
associated wheel, and pulling back on a lever increases the
REVERSE speed.
The ground speed control levers cannot be moved from the
NEUTRAL position until the parking brake lever is moved to the
DISENGAGED position.
Note: The further a lever is moved away from the neutral position
the faster the drive wheel will turn.
See Driving the Zero-Turn Riding Mower section for steering
instructions.
Parking Brake: Pull the parking brake lever rearward and
up to engage the parking brake. Move the lever fully forward
and down to disengage the parking brake.
Releases the parking brake. Disengage
Locks the parking brake. Engage
Operator Platform: The operator stands on the operator
platform while driving the machine. Keep both feet on the
operator platform at all times.
The operator platform is integral to the safety interlock system:
• If the operator steps off the operator platform while the unit
is running and the PTO switch is engaged, the PTO will
shut off.
Transmission Oil Fill: Transmission oil is added through the
hydraulic oil tanks. It also serves as extra holding capacity for
oil as the transmissions heat up and the hydraulic oil expands.
See Check / Fill Transmission Oil for oil level check and fill
procedures.
Fuel Tank Cap: To remove the cap, turn counter-clockwise.
Transmission Release Levers:
Control Name Icon
Transmission Release Levers
This unit is equipped with two transmission release levers. The
transmission release levers deactivate the transaxle so that the
unit can be pushed by hand. Both transmission release levers
must be in the same position whether you are driving the unit
or pushing it by hand. See
Pushing the Unit by Hand for
operational information.
Briggs & Stratton Fuel Injected Models:
7
Carbureted Models:
8
Kawasaki Fuel Injected Models:
13