Not for
Reproduction
13
5
Cutting Height Adjustment Pin
Deck Lift Lock Lever
Throttle Control:
The throttle controls engine speed. Move
the throttle forward to increase engine speed and back to
decrease engine speed. Always operate at FULL throttle
when mowing.
Fast throttle speed.
Slow throttle speed.
Parking Brake:
Pull the parking brake lever back, in
towards the operator and allow it to travel forward to engage
the parking brake. Pull the parking brake lever back, out away
from the operator, and allow it to travel forward to disengage
the parking brake.
Note:
To start the unit the parking brake must be engaged.
Disengage
Releases the parking
brake.
Engage
Locks the parking
brake.
Ignition Switch:
The ignition switch starts and stops the
engine, it has three positions:
OFF:
Stops the engine and shuts off the electrical
system.
RUN:
Allows the engine to run and powers the electrical
system.
START:
Cranks the engine for starting.
Note:
Never leave the ignition switch in the RUN position with
the engine stopped—this drains the battery.
Choke:
Close the choke for cold starting. Open the
choke once the engine starts. A warm engine may not require
choking. Pull the knob UP to close the choke. Push the knob
DOWN to open the choke.
PTO (Power Take Off) Switch:
The PTO switch
engages and disengages the mower blades. Pull UP on the
switch to engage, and push DOWN to disengage.
Hour Meter:
This unit is equipped with an hour meter
that records the number of hours that the engine has been
run.
Transmission Oil Fill:
Transmission oil is added through the
hydraulic oil tanks. It also serves as extra holding capacity
for oil as the transmissions heat up and the hydraulic oil
expands. See
Check / Fill Transmission Oil
for oil level check
and fill procedures.
Transmission Release Levers:
Callout
Control Name
Transmission Release Levers
Each transmission is equipped with a transmission release
lever. These lever deactivate the transmissions so that the
machine can be pushed by hand. Both transmission release
levers must be in the same position whether you are driving
the machine or pushing it by hand. See
Pushing the Rider by
Hand
for operational information and control location.
Fuel Level Gauge:
Displays the fuel level in the tank.
Fuel Tank Cap:
To remove the cap, turn
counter-clockwise
.
Ground Speed Control Levers:
These levers control the
ground speed and direction of the rider. The left lever controls
the left rear drive wheel and the right lever controls the right
rear drive wheel.
Содержание 500S Series
Страница 1: ...N o t f o r R e p r o d u c t i o n...
Страница 36: ...N o t f o r R e p r o d u c t i o n...
