82
T380D-T430D
Rev. 1.0
USE AND OPERATION
06-Lavoro su siepe
6.3.4 Work with arm close to a vertical position
Do not work if the shredding flail head is not clearly visible.
DANGER
Take the following precautions:
►
Before starting work, check that there are no foreign bodies, such as wires, stones or other items that could be
thrown by the flail head.
►
Before cutting the hedge, put up a danger notice advising people to keep at a safe distance due to the cut
material being thrown.
Before each start-up and during use of the machine, make sure that there are no people and/or animals within
a radius of 100 m.
This activity is EXTREMELY dangerous, because these work configurations do not allow
the guards applied to hold back any foreign bodies inside the flail head as it is not resting
horizontally on the ground.
Work with extreme caution outside built-up areas and stop work immediately if there are
people and/or animals within a radius of 100 metres.
DANGER
Cut the hedge in a side and at its foot (Points 1 and 2). In this way a lateral barrier is left that is sufficient to avoid
detritus being expulsed through the flail head.
Move to the other side of the hedge with the tractor to carry out cutting (Points 3, 4 and 5). In this way the operator
always has a clear view of the shredding flail head.
Do not cut with the flail head on the opposite side of the hedge to the tractor (Point 6).
In this case it is impossible to be aware of potential hazards and the presence of persons
and/or things.
DANGER
To cut hedge branches with a diameter greater than 1.5 ÷ 2 cm
(0.59 ÷ 0.78 in), activate the flail holder rotor in the
same direction as the wheel of the tractor (Point 7). In this way the material is directed towards the bottom or the rear
part of the machine.
Proceed in an opposite direction only for finishing operations.
Содержание T380D left
