60
T380D-T430D
Rev. 1.0
TRANSPORT AND INSTALLATION
4.14
04-Collegamento testata (T430)
TID100
2
1
A
C
B
4.6.1
Connecting the flail head
1)
Ensure that the arm is open.
2)
If you do not have the dual effect kit (Chapter 11), the arm falls by gravity and, when no tool is fitted, it is
necessary to perform coupling operations using a hoist or fork-lift truck.
3)
Start the tractor and regulate the PTO to about 300 rpm.
4)
Raise the flail head with the aid of a lift [and rest it near the end of the arm (see the use and maintenance
manual for the location of the lifting points of the flail head)].
5)
Lower the arm so that the tie plate fits with the flail head.
6)
Secure the flail head with the 4 screws (
1
) M16x40 and their washers.
7)
Switch off the engine, apply the parking brake and remove the ignition key from the dashboard.
8)
Make sure that there is no pressure inside the hydraulic system.
9)
Connect the delivery (
A
) and discharge (
B
) pipes to the hydraulic motor (
2
), after exhausting the system
pressure, using the rotor selection lever.
10)
Connect the drain pipe (
C
) to the hydraulic motor (
2
).
Hydraulic pipe identification
code
A
2 YELLOW bands
B
1 YELLOW band
Содержание T380D left
