FERREX BDG 915, Руководство пользователя

Страница: 16 / 22

20
Working instructions/Cleaning and maintenance
Sanding outside curves on sanding disc Fig. 19
Always sand outside curves using the sanding disc and moving the workpiece (W) from the
left side of center as shown in Figure 19
• Hold the workpiece firmly, keeping fingers away from the sanding disc.
• Keep the curve pressed firmly against the sanding disc moving work evenly on the left side
of the sanding disc.
Warning: Applying the workpiece to the right side of the sanding disc could cause the work-
piece kickback. Failure to heed this warning could result in serious personal injury.
IX. Cleaning and maintenance
m
WARNING! Prior to any adjustment, maintenance or service work switch off the machine
and disconnect the mains power plug!
Cleaning
• Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe
the equipment with a clean cloth or blow it with compressed air at low pressure.
• We recommend that you clean the device immediately each time you have finished using it.
• Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the plastic parts of the equipment. Ensure that no
water can seep into the device.
Maintenance
After using your belt/disc sander, clean it completely and lubricate all sliding and moving parts.
Apply a light coat of automotive type paste wax to the worktable to help keep the surfaces clean.
Motor housing
Frequently blow out any dust that may accumulate inside the motor housing.
Changing drive belt.
Note: Excessive tightness on the drive belt may cause increased noise and overload the motor.
Excessive looseness on the drive belt may cause the drive belt to fail prematurely and make a
severe chattering noise.
m
ATTENTION! The drive belt should only be changed by a specialist.
Service information
Please note that the following parts of this product are subject to normal or natural wear and
that the following parts are therefore also required for use as consumables.
Wear parts*: Carbon brushes, v-belt, grinding medium
* Not necessarily included in the scope of delivery!