FERREX BDG 915, Руководство пользователя

Страница: 14 / 22

18
Attachment and operation
Using the belt/disc sander as portable tool
If your belt/disc sander is to be used as a portable tool, it is recommended you fasten it per-
manently to a mounting board that can easily be clamped to a workbench or other stable
surface.
The mounting board should be of sufficient size to avoid tipping while belt/disc sander is in
use. Any good grade plywood or chipboard with a 3/4 in. (19 mm) thickness is recommended.
• Mark holes on board where belt/disc sander is to be mounted using holes in the base as a
template for hole pattern.
• Follow last three steps in section Mounting Belt/Disc Sander to Workbench.
If lag bolts are used, make sure they are long enough to go through holes in belt/disc sander
base and material the belt/ disc sander is being mounted to. If machine bolts are used, make
sure bolts are long enough to go through holes in belt/disc sander, the material being mounted
to, and the lock washers and hex nuts.
On/Off switch (12)
• The grinder/sander can be switched on by pressing the green button „1“.
• To switch off the grinder/sander you must press the red button „0“.
Warning: Do not reach across the sanding disc to turn the belt/disc sander ON or OFF.
Contact with the sanding disc can result in serious personal injury.
Grinding/sanding
• Always hold the workpiece firmly during grinding/ sanding.
• Do not exert excessive pressure.
• To prevent the abrasive paper from becoming worn on one side, the workpiece should
be moved to and from on the grindinög/sanding belt or grinding/sanding plate as you
grind/sand.
• Important! Pieces of wood should always be sanded with the grain to prevent them
splitting. Important. If the grinding wheel or the grinding/sanding belt becomes jammed
during operation, please remove the workpiece until the tool reaches its top speed
again.