11
© Ferno (UK) Ltd. FERNO/MAN/R5/08/18/207/UK
Compact 2 Track Chair
4.3 Attaching the Track - Method 2
When the Chair is not occupied, an alternative method
for attaching the Track is recommended, which requires
less bending and therefore better from a manual handing
prospective. Again check first that the latches on the back
of the chair are open before attempting to attach the track.
1. Lay the Track on the floor and lift the Chair into place,
locating the axle bar in to the lower Track lock.
4.4 Deploying the Track for Use
Once the Track are attached to the chair, they may be
unfolded for use.
Whilst holding the Chair secure from the rear, pull the red
‘Pull to Open’ bar forwards and down, until the Track locks
into position.
Operating the Chair
2. Push the Chair axle securely into the lower lock until it is
locked in place.
3. Rotate the Track upwards and lock in place as described
previously in steps 2-3 on page 10.
Figure 16 - Preparing to attach Track to unoccupied
Chair
Figure 18 - Pulling Track out for use
Figure 19 - Chair with Track deployed ready for use
Figure 17 - Track attached to Chair back via
push-to-close latches
