OPERATING INSTRUCTIONS
This storage heater takes in Energy
when electricity tariffs are low and
dissipates it when tariffs are normal.
OPERATION
SAFETY INSTRUCTIONS
1. Ventilate rooms well during commissioning
2. Do not move the heater in any way once installed
without the services of a competent electrician.
3. Do not cover the heater with clothing etc. at any time
or position furniture close to or against the heater.
4. Ensure a clearance of at least 150mm between heaters
and curtains.
5. Floor standing heaters must only be fitted with the
back against a wall.
6. Should your heater fail to operate either employ the
services of a competent electrician
ALSO REFER TO COVER PAGE
COMMISSIONING
Set both the Input Control and the Output Control to 6
and leave the heater for 48 hours.
Following the commissioning period adjust the
controls as stated below.
CONTROL FUNCTIONS
THE INPUT CONTROL
SETTING THE CONTROLS
The controls are located under the hinged flap at the top right
hand corner of the heater.
To adjust the controls on the heater use a coin and engage it
in the clots provided on the top surface of the knob. There
are no user adjustable controls on the WMX706.
CLEANING
To maintain the appearance of the heater wipe occasionally
with a dry cloth when the heater is cool.
Do not use abrasive powders of furniture polish.
AFTER SALES SERVICE
Your Storage Heater is guaranteed for
2
year
s
from date of
purchase. We undertake to exchange or repair within the
period, any part found to be defective due to a manufacturing
fault. This guarantee does not affect you statutory rights.
Should you require after sales service, please contact the
supplier through whom you purchased the heater
.
Please do not initially return faulty appliance, or part of an
appliance, to us as this may result in transit damage and/or a
delay in providing service.
Let us know your difficulty quoting the model number and
serial number (located along the wall bracket). We will then
take the appropriate action.
THE OUTPUT CONTROL
For all models except WMX706N
Most of the stored heat is radiated from the casing during the
discharge period. However, some of the heater is emitted
through the grille at the top of the heater and this additional
heat (or boost) is regulated by the Output Control.
With this set to 6 the boost begins in the early afternoon.
Turning the control towards 1 will progressively delay the
commencement of the boost. At 3 the boost will start in the
evening. Once set, the boost will repeat itself automatically
day after day.
If no boost is required e.g. when the room will be unoccupied
for a long period, set the Output Control to 1. With the control
in this position, the heater will take less energy during the
next charging up period.
For models WMX712, 718, 724 only:
Initially set the input to 4. If the heater does not maintain a
satisfactory room temperature the following day this setting
should be increased. Conversely if the room temperature is
too high this setting should be reduced.
The input control should only require seasonal adjustments.
Fenix Trading s.r.o.
Slezská 2, 790 01 Jeseník
Czech Republic
tel.: +420 584 495 304
fax: +420 584 495 303
e-mail: [email protected]
www.fenixgroup.cz