INSTALLATION INSTRUCTIONS
PREPARATION
The heater will arrive
separately from its
storage bricks, the
following bricks will
be required:
Model 706 - 4 bricks
Model 712 - 8 bricks
Model 718 - 12 bricks
Model 724 - 16 bricks
Only heat resisting cable (min. rating T85) should be
used. The wires in the mains cable will be coloured as
follows:-
GREEN & YELLOW
-
EARTH
BLUE
-
NEUTRAL
BROWN
-
LIVE
SUGGESTED FIXINGS
SOLID BRICK/BLOCK:
No. 10 Rawlplug fibre inserts,
5.5mm drill bit. Drill hole 6mm deeper than rawlplug
length.
PLASTERBOARD
- If possible locate studding and use
No. 10 woodscrews directly into the wood, otherwise
M5 rawlplug intersets are suitable.
NOTE: FOR OTHER WALL TYPES
(e.g. Timber frame
and hollow concrete)
SEEK SPECIALIST ADVICE.
FIXING ASSEMBLY
ENSURE THAT FIXING KIT AND FEET HAVE BEEN
LOCATED BEFORE DISPOSING OF PACKAGING.
Fit the feet with the open end of the foot to the front of
the heater. Secure each foot using two taptite screws
provided in the fixing kit.
1.
2.
2.
WARNING
- This appliance must be earthed
Place the heater on its feet and in the desired position
against the wall. Ensure the heater is based on a firm
level surface at least 75mm from any end wall and at least
250mm below any shelf or similar projection. Cut away any
gripper rod or carpet which would prevent the heater sitting
firmly on the floor.
3
.
3
.
Mark the position of the two outside corners of the wall
bracket with the heater pushed tight against the wall.
Remove the wall bracket from the heater by removing the
screw at each end. Place the heater to one side and reposition
the bracket against the wall using the corner marks for
alignment.
Four fixing positions must be chosen for the 724, three for
the 718 and two for the 712 and 706. Mark the positions
for the fixing holes - two at the extreme ends and the others
spaced evenly between them. Remove the bracket from the
wall, drill the holes in the positions marked, and insert suitable
fixings previously described. Secure the wall bracket to the
wall.
4
.
4
.
If mains connection is to be made from the left side, at
this point the mains lead must be secured to the back of
the heater using ties provided in the fixing kit.
5
.
5
.