6.3 Magnet Sensor
•
Always use magnet sensor in Temperature Mode. If the sensor got broken or not
connected well, the machine will give “TEMP SENSOR NOT CONNECTED!” error and
generates an acoustic signal after few seconds of operating and it will turn back to
main menu. If sensor doesn't located properly or part's heat is not increasing then
machine will give “PROBE ERROR!!!” and generates an acoustic signal in two
minutes then it will turn back to main menu.
•
You can use magnet sensor to check the workpiece's teperature while operating
the machine in Time Mode.
•
Magnet sensor's surface always has to be clean.
•
Heated workpiece should not touch the magnet sensor's cable.
•
Magnetic sensor always has to be attached to inner ring of the bearing. Otherwise,
it may couse damage on the bearing's surface.
•
Magnetic sensor always has to be attached to metal surface because of its
magnetic end. Therefore be sure that metal protect attached to magnetic end or
magnet sensor attached to metal surface when you are not using magnetic sensor.
CAUTION!: Do not use magnet sensor, if you will heat the workpiece over 250 ºC.
That will give a damage to magnet sensor. If you want to heat the workpiece over
250 ºC, please use our special production magnet sensor.
CAUTION!: Always attach the magnet sensor to metal surface or attach metal
protector to magnetic end.
6.4 Operating Modes
FeniX induction heaters can be operated in two different heating modes. In main menu
you will see the Temperature Mode and the Time Mode sections. In Temperature Mode,
the machine generates an acoustic signal and returns to main menu, when tempereture
of the workpiece's reaches to set temperature. In Time Mode, on the other hand, the
machine generates an acoustic signal and returns to main menu, when countdown
finishes. In both modes you can select different power levels during operation.
10/16
Feni
X
Induction Heaters