The engine may be equipped with an oil draining pump (e.g. marine engines), in that case use the
pump to drain the oil.
4.
When the oil sump is empty, refit the plug with a new washer.
5.
Clean the oil filler plug and the surroundings.
6.
Fill new oil to the prescribed level (upper mark line on dipstick) through the filler hole. Note the
capacity of the oil filter.
7.
Take used oil to a proper disposal point.
1.6.5.2 Change oil filter
NOTE:
Engine Warranty is valid only when original AGCO Parts filter elements are used.
Procedure
1.
Before removing the oil filter clean the surroundings of it.
2.
Use the loop tool to remove the used oil filter.
3.
Lubricate slightly the rubber gasket of the new oil filter with clean motor oil and clean the sealing
faces.
4.
Rotate the new oil filter carefully until the gasket touches the opposite surface.
5.
Tighten the oil filter ¾ rounds (or one (1) full round, if the height of the oil filter used is 260 mm). Use
an appropriate tool for tightening if necessary.
6.
Wipe off any oil run onto the chassis.
7.
Do a check for the quantity of oil in the engine.
8.
If it is necessary, add oil.
9.
Start the engine. Do not race.
10.
Make sure that no oil is leaking from the oil filter.
11.
Take the used oil filter to a proper disposal point.
1.6.5.3 Update the engine software
Engine software updates bring new features to the engine controller that improve the performance of the
engine, update diagnostic features and help to protect the engine and its emission components over the
engine lifetime.
Procedure
1.
Use the EDT and examine, if new software is available for the machine.
2.
Update the engine software, if possible.
GUID-EFF85558-12E7-4C73-B2A6-23CF6EC7831A [V5]
GUID-1E23D7F6-0FCA-4D43-9400-74EA1657CCF5 [V2]
1. General
Rubber Track Tractor
1-31
79037272A
