Fema Electronica K40-CR, Руководство пользователя

Страница: 8 / 28

FEMA ELECTRÓNICA . Series K . K40-CR
8
Press ‘SQ’ (
<
) for 1 second to access the ‘ configuration menu ’.
For a description on how to operate inside the menus see section
1.10
. For a full vision of the ‘
configuration menu
’ structure see
section
1.13
.
To configure the initial set up of the instrument, select the viewing
format, configure the up or down counting mode and assign the pre -
set value.
Enter the ‘
Function mode ’ (‘ Func ’) menu and select the ‘ View ’ for -
mat desired.
• ‘ MM.SS ’ - clock format, minutes and seconds.
• ‘ hh.MM ’ - clock format, hours and minutes.
• ‘ dd.hh ’ - clock format, days and hours.
• ‘ SSSS ’ - counter of seconds.
• ‘ SSS.S ’ - counter of seconds with one decimal.
• ‘ SS.SS ’ - counter of seconds with two decimals.
• ‘ MMMM ’ - counter of minutes.
• ‘ MMM.M ’ - counter of minutes with one decimal.
• ‘ MM.MM ’ - counter of minutes with two decimal.
• ‘ hhhh ’ - counter of hours.
• ‘ hhh.h ’ - counter of hours with one decimal.
• ‘ hh.hh ’ - counter of hours with two decimal.
Access the ‘ Counting direction ’ (‘ dIr ’) and select ‘ uP ’ for up counting
or ‘ doWn ’ for down counting.
At the ‘ Preset ’ (‘ PrSt ’) menu select the preset value. The preset value
will load on display when reset function activates. See section
1.7
for
a description on the different activation modes for the reset.
Additional configuration parameters for the instrument.
The ‘
On Power Up ’ (‘ on.Pu ’) menu configures functions to apply at
start-up. It applies only to instrument restart after power loss. It does
not apply to instrument restart due to change in configuration.
• parameter ‘
Delay ’ (‘ dLAy ’) assigns a waiting time in seconds. The in -
strument waits the configured time before starting normal function.
During this waiting time, the display shows all decimal points on in
flash mode, all alarms are in ‘oFF’ state, there is no signal acquisition
and there is no communications or control being performed. After
the configured time is over, the instrument starts in normal function.
Application - the start-up process for an automation system implies
that different parts of the system (engines, actuators, controllers, ...)
have different start-up times. The ‘Delay’ function gives time to the
instrument to wait until the slowest part of the system is fully func -
tional before executing actions on the system (signal reading, relay
activation, ...)
.
• the ‘ Reset ’ (‘ rSt ’) parameter will execute a reset of the counter
each time the instrument is restarted.
1.12.2 Configuration
1.12 Configuration menu
1.12.1 Initial set-up
Function
mode
Preset
Preset value
-1999 to 9999
Counting
direction
Up
Down
View format
Configuration
On power-up Delay Seconds
Reset
State
0 to 9999
0.0 to 999.9
0.00 to 99.99
0 to 9999
0.0 to 999.9
0.00 to 99.99
0 to 9999
0.0 to 999.9
0.00 to 99.99
0.00 to 99.59
0.00 to 99.59
0.00 to 99.23