Felo FW-06, Руководство по обслуживанию

Страница: 32 / 134

Spot Inspection and Adjustment
28 Service Manual
■
Spot inspection and adjustment of the steering column
1. Place the motorcycle vertically on a flat and hard surface.
2. Perform the following spot inspection:
a. Hold the steering handlebar and shake it
from left to right to check the limit block.
b. Check if the handlebar and front wheel
steering are in the same direction.
c. Hold the steering handlebar, and tightly hold
and then press down the front brake to check
if there is any gap.
If the steering handlebar is stuck or loose or
shows a gap, adjust the steering handlebar.
If the steering column is not in the same
direction as the wheel, check the handlebar
and shock absorber. If the steering column
limit block is damaged or the steering column
is deformed, replace the steering column.
3. Adjust the steering column gap.
a. Fix the lower adjusting nut
1
with a crescent wrench,
and completely loosen the upper fixing nut
2
.
b. Loosen the lower adjusting nut with a crescent
wrench, and turn the steering rod to adjust the gap.
c. Adjust and tighten the lower adjusting nut
1
clockwise with your hands, and then loosen it
counterclockwise by 45 degrees.
d. Fix the lower adjusting nut
1
with a crescent
wrench, and tighten the upper fixing
nut
2
to the specified torque.
After the steering column gap has been
adjusted, check the left and right shock
absorbers by turning the steering column to
check if the steering column is loose or stuck.
If yes, please check the upper and lower shaft
washers and bearings. For information on how
to inspect the front fork, please see Page 83.
Lock nut with four openings 58 N·m
Tighten the octagonal lock nut clockwise with a torque of
3-5 N·m (this is the torque value if the nut is adjusted by
hand, and may vary according to the individual). Tighten the
octagonal lock nut counterclockwise with a torque of 58 N·m.
■
Replace the gear oil in the gearbox
1. Support the motorcycle at the side stand on a flat,
hard surface.
2. Place the oil tray under the gearbox to collect the
oil, remove the oil tank cap and drain bolt until the
gear oil is completely drained.
3. Install the following parts.
• Drain bolt
Tightening torque 25 N·m
4. Add oil.
• Add 350 mL of gear oil to the gearbox.
Recommended gear oil GL5 80W-90
5. Install the following parts.
• Install the oil tank cap
2
1
58 N·m
58 N·m When it is locked
counterclockwise
Oil tank cap
Drain bolt