2
3
ENGLISH
Lotus™ VE Sit-Stand
ASSEMBLY
SAFETY INSTRUCTIONS/WARNING
PARTS REQUIRED
Ensure that the sit stand is anchored tightly to the desk/table before using it to prevent injury or damage to the product!
≤ 20 lbs
≤ 9.07 kg
≤ 5 lbs
≤ 2.27 kg
Single Monitor
A Tower pole x1
B Base plate x1
C Platform x1
D VESA assembly x1
E Clamp bar x1
Additional Parts for
Dual Monitor
G Dual VESA Assembly
Hardware
H M6X12mm Bolt x6
I M6x25mm Bolt x4
J Cable Clip x3
K M4 x 12mm Bolt x8
L M3x55mm Allen Key x1
M M4x55mm Allen Key x1
N M6x95mm Allen Key x1
O M8 x 80mm bolt x2
P 13mm Hex Wrench x2
STEP 1
Attach the Tower Pole to the Base Plate
• Choose one of three locations to attach the Tower Pole to the Base Plate
depending on your desk depth. Furthest set to the rear for 23.6” (600mm),
middle set for 27.5” (700mm) and the front set for 31.5” (800mm)
depth desks.
• Use four M6x25mm bolts and the M4x55mm Allen Key to attach the Tower
Pole to the Base Plate.
STEP 2
Prepare Clamp
• The base clamp comes pre-assembled to fit standard
thickness desks (see option A image). If your desk is
thicker you can remove the two M6x12mm bolts using
the M4x55mm Allen Key and flip the base clamp (see
option B image). Re-install the M6x12mm bolts using the
M4x55mm Allen Key.
• Insert two M8x80mm bolts into the Base Clamp, only a
few turns each.
Option A
Option B
STEP 3
Attach Base to Table
• Slide the Base Plate onto the rear of the desk.
• Place the Clamp Bar on top of the M8x80mm bolts.
Ensure the tip of the bolts align to the holes on the
Clamp Bar.
• Tighten the M8x80mm bolts with the M6x95mm Allen
Key until the Clamp Bar is secured to the desk.
I
M
• WARNING: PINCH POINT! DO NOT PUT HANDS OR OTHER OBJECTS UNDER THE PLATFORM
DURING OPERATION. SERIOUS INJURY MAY OCCUR.
• WARNING: DO NOT EXCEED MAXIMUM STATED WEIGHT CAPACITY. SERIOUS INJURY OR PROPERTY
DAMAGE MAY OCCUR.
• CAUTION: Lift hazard! Two people are required to move workstation. Serious injury may occur.
• Ensure cable lengths are long enough and follow the cable routing instruction in this manual.
Failure to follow these instructions may result in equipment damage or personal injury.
• DO NOT lean on the keyboard platform.
• This product has a gas strut lift assistance and should never be used with less than 5 lbs. (2.2kg)
of weight.
• Make sure the desk or mounting surface is level and can support the combined
weight of the workstation and accessories.
• Remove all equipment and accessories from the workstation before moving.
• Manufacturer certifies that product meets or exceeds applicable ANSI/BIFMA standards.
A
H
I
K
L
M
N
O
P
B
C
D
E
G
J
M
O
N
N
N
M
E
E
LotusVE_SitStand_872346__RevC_053018.indd 2-3
6/1/18 10:02 AM
