Page 4
Step #2: assemble slider mounts
IMPORTANT:
When assembling the slider mounts, the groove on the slider bars must be at the bottom.
• Slide the VESA mount assembly onto the slider bar. Center the assembly on the slider bar.
• Install the M4x9 set screw into the bottom of the VESA mount assembly. Use the 2mm Allen key to tighten the set screw to hold the assembly in place. Be sure the
screw tip fits into the groove on the slider bar.
— After the monitor has been installed, the VESA mount can be moved anywhere along the slider bar by loosening the locking screw no more than one full turn, so that
it stays inside the groove. Be sure to re-tighten the screw to secure the monitor in the desired position.
slider bar
VESA mount
assembly
2mm
Allen key
set screw
M4x9
groove
Step #3: install first connection sleeve onto post
The first connection sleeve holds the two fixed-motion monitor arm assemblies.
• Remove the locking ring from the connection sleeve.
— Rotate the locking ring counterclockwise to unlock it and then lift it off.
• Slide the connection sleeve onto the post with the screw toward the rear.
• With the sleeve at approximately one-third the height of the post, securely tighten the screw using
the 4mm Allen key.
connection
sleeve
one-third
height
of post
to unlock,
turn locking ring
counterclockwise
lift off
4mm
Allen key
KataEX3-FMS
Assembly
