Page 6
KataEX2-FF
Assembly
Step #6: install lockout set screw(s), if desired
Default rotation of the fixed arms is 360°. Installation of a lockout set screw limits rotation to 180°.
• To lockout fixed arm rotation, install M4x15 set screws. Tighten each screw, then back it off one turn. The screws fit in the underside of the arm stems and fixed arms.
— Installing a set screw in the front hole allows 180° rotation to the right only. A set screw in the rear hole allows 180° rotation to the left only.
— In the example below, to prevent the inner fixed arms from rotating to the rear (a left rotation with the left arm and a right rotation with the right arm), install a set
screw in the front hole on the left arm stem and in the rear hole on the right arm stem. The outer fixed arms are allowed their full 360° of rotation.
• The fixed arms must be in their allowed range of rotation when installing the lockout set screws.
Step #7: organize cables and cords
• Capture the cables and cords with the cable covers. Slide the cable covers as shown to attach them to the monitor arms.
• Snap the cable clips onto the post and into the recessed groove above the base.
• Route the monitor cables and power cords toward the rear by slipping the cords into the opening on the cable clips.
front
rear
set screw
M4x15
2mm
Allen key
front
rear
180°
180°
360°
monitors
not shown
360°
outer
fixed arm
inner
fixed arm
capture
cables
with clips
snap on
cable clips
slide in
slide in
slide in
