Page 9
up to 3.2"
clamp to
worksurface
0.5" – 2.1"
0.5" – 1.5"
flush
against
clamp
gap
clamp in top two holes on bracket (standard)
clamp in bottom two holes
KataEX
Assembly steps
tighten grommet knob to secure
grommet bar
center bolt in grommet hole
grommet base assembly
maximum thickness = 1.7"
Follow either
step #1a for clamp mounting or step #1b for grommet mounting.
Step #1a: attach base assembly to worksurface — clamp mount
With the clamp in the top two holes of the clamp bracket, the thickness of the worksurface must be
between 0.5" and 2.1". To mount the rear of the clamp flush against the worksurface, the thickness
must be no more than 1.5".
• Loosen the clamp sufficiently to be able to slide it easily onto the worksurface.
• Clamp the assembly to the worksurface in the desired position. Be sure to tighten the clamp securely.
For a table thickness greater than 2.1", secure the clamp to the bottom two holes of the clamp bracket.
• Use the 4mm Allen key to remove the two screws holding the clamp to the bracket.
• Re-install the clamp to the bottom two holes of the bracket.
Step #1b: attach base assembly to worksurface — grommet mount
Maximum thickness of the worksurface for grommet mounting is 1.7".
• Place the base assembly over the grommet hole with the bolt centered.
• Insert the grommet bar onto the grommet bolt and then screw on the grommet knob. Tighten the grommet knob securely to hold the base assembly in position.
