Page 5
Step #3: clamp FlexCharge4CX unit to worksurface and mount power strip
• Position the unit in the desired location and clamp it securely to the
worksurface by tightening the triangle knob.
• Mount the power strip underneath the worksurface in the desired location
using the double-sided tape and four M4x14 wood screws.
— Note: The double-sided tape is only temporary and is not intended for permanent installation.
• Plug the power strip into the AC outlet and flip the switch on.
You are now ready to use the eight AC power outlets (six on the power strip, two on the
power module) as well as the USB-A and USB-C charging ports located on the power
module.
worksurface
triangle knob
FlexCharge4CX Edge mount
Grommet mount
The grommet mount method is similar to the
edge mount method, except that the assembly is
clamped to the edge of a grommet hole, rather
than the edge of the worksurface. Minimum
diameter of the grommet hole is 2.3".
