Felisatti SG6/750, Руководство по эксплуатации

Страница: 5 / 41

5
DECLARATION OF CONFORMITY
We hereby declare, under our sole
responsibility, that the
FELISATTI brand
products described in this manual comply
with the following standards or standard
documents: EN60745-1:2009, EN60745-
2-5:2011, EN55014-1:2006+A1, EN55014-
2:1997+A1+A2, EN61000-3-2:2006+A1+A2,
EN61000-3-3:2008 in accordance with
EU Directives 2006/42/EC, 2006/95/EC,
2004/108/EC, 2002/95/EC
We reserve the right to make technical changes 09/2012
Santiago Lopes Jordi Carbonell
any reason, switch off the power tool and hold the power
tool motionless until the wheel comes to a complete stop.
Never attempt to remove the cut-off wheel from the cut
while the wheel is in motion otherwise kickback may occur.
Investigate and take corrective action to eliminate the
cause of wheel binding.
Do not restart the cutting operation in the workpiece.
Let the wheel reach full speed and carefully re-enter the
cut. The wheel may bind, walk up or kickback if the power
tool is restarted in the workpiece.
Support panels or any oversized workpiece to
minimize the risk of wheel pinching and kickback. Large
workpieces tend to sag under their own weight. Supports
must be placed under the workpiece near the line of cut
and near the edge of the workpiece on both sides of the
wheel.
Use extra caution when making a “pocket cut” into
existing walls or other blind areas. The protruding wheel
may cut gas or water pipes, electrical wiring or objects that
can cause kickback.
Safety warnings speciic for polishing operations
Do not allow any loose portion of the polishing
bonnet or its attachment strings to spin freely. Tuck away
or trim any loose attachment strings. Loose and spinning
attachment strings can entangle your ingers or snag on the
workpiece.
Safety warnings speciic for wire brushing
operations
Be aware that wire bristles are thrown by the brush
even during ordinary operation. Do not overstress the wires
by applying excessive load to the brush. The wire bristles
can easily penetrate light clothing and/or skin.
Allow brushes to run at operating speed for at least
one minute before using them. During this time no one is
to stand in front or in line with the brush. Loose bristles or
wires will be discharged during the run-in time.
Direct the discharge of the spinning wire brush away
from you. Small particles and tiny wire fragments may be
discharged at high velocity during the use of these brushes
and may become imbedded in your skin.
Additional safety warnings
Use suitable detectors to determine if utility lines are
hidden in the work area or call the local utility company for
assistance. Contact with electric lines can lead to ire and
electric shock. Damaging a gas line can lead to explosion.
Penetrating a water line causes property damage or may
cause an electric shock.
Release the On/Off switch and set it to the off position
when the power supply is interrupted, e. g., in case of
a power failure or when the mains plug is pulled. This
prevents uncontrolled restarting.
Secure the workpiece. A workpiece clamped with
clamping devices or in a vice is held more secure than by
hand.