38
max 2 mm
max 2 mm
!
!
"
!
"
Edgebander
G 330 / G 360 / G 380
Inspecting and adjusting settings
Fig. 8-14: Flush trimming unit
The high-frequency motors of the trimming unit are turned
on using the middle button. The spindles are used for
trimming protruding edges on both sides of the workpi-
ece. If the workpiece is moving away from the trimming
spindles, the unit will be copied from the buttons. Depen-
ding on the spindle tool and edge thickness, a sharp,
beveled or rounded trim can be achieved. The standard
equipment includes two spindle tools – top, bottom
(right / left) – with a 2 mm radius (3 mm) and 3° slope.
The spindles are equipped with extraction nozzles with a
diameter of 60 mm and connected directly to the central
dust extractor. The removable protruding edge is max. 2
mm per side.
The cutters turn in the opposite direction to the panel
feeding. The upper flush trimmer regulates itself automa-
tically when changing the tool thickness as it is attached
to the pressure bars.
8.10 Combination milling unit
8.10.1 Operation - Combination milling unit
!
Upper flush trimmer
"
Bottom flush trimmer
Fig. 8-13: Edge protrusion
Warning! Risk of injury!/Risk of material damage!
Shaping tools must be handled with special care.
We recommnend using exclusively original FELDER tooling (see FELDER Catalogue).
Note:
Exchanging Shaper - See chapter entitled: Maintenance/Service
Inspecting and adjusting settings
1.
Switch the machine off and ensure that it cannot
be switched on again Open the rear access door.
Compressed air must be available.
Set the front radius, then the rear radius:
2.
Loosen the clamping screw.
3.
Adjust radius milling cutter with setting wheel (max.
¼ turn - )
4.
Tighten the clamping screw.
!
Setting wheel radius front
"
Setting wheel radius rear
§
clamping screw
Fig. 8-13: Setting Radius
8.9.1 End trimming unit - Setting Radius (G 380)
