FAQ • G6 MAX
TROUBLE SHOOTING
1) The gimbal vibrates non-stop while I am changing the camera and lens. How
do I fix it?
1
Before turning the gimbal on, please make sure all those three axes are
balanced properly.
2
Please set the motor strength to "Auto Adaption”: you can single-tap the
power button, then switch the interface to page 2 on the OLED; next, select
the “Auto Adaption” option by pushing the joystick up or down. Confirm the
option by pushing the joystick to the right.
2) What do I do if the G6 Max is not level?
1
Initialize the gimbal
Single tap the power button twice, then switch the interface to interface 3
on the OLED. Thereafter, select the “Initialize” option by pushing the joystick
up or down.
Confirm the selection by pushing the joystick to the right.
After that, the motors will lose power. Wake the gimbal up by single-tapping
the mode button while the OLED shows “Tap mode to awake it after INIT”.
2
Calibrate the gimbal via “Horizontal Calibration” in the App.
3) I can see the GoPro’s Wi-Fi signal on the phone’s Wi-Fi list but not in the
Feiyu ON app. Why is that?
Please ensure the GoPro is not connected to another device such as the App
for GoPro itself, smart remote, and phone’s Wi-Fi etc.
Once you have ascertained the above, please check if you had set up the
bands for the GoPro to 2.4GHz. The G6 Max only detects the GoPro if it is set
up at 2.4 Ghz.
4) I can see my camera’s Wi-Fi signal in the App but I am not able
to connect to the Wi-Fi. How do I fix it?
1
Please turn off the smartphone’s Wi-Fi and disconnect the camera from
other devices such as remote etc.
2
Please uninstall the camera’s App from your phone.
3
Please make sure you have entered the password correctly
(be mindful of spaces, capital and lower cases)
4
Please disconnect the camera’s Wi-Fi.
5
Please remove the battery and install it again. Thereafter, restart the gimbal.
It is recommended to reset the camera’s Wi-Fi and password before
reconnecting.
