Fein RSG Ex 1500 A Series, Руководство пользователя

Страница: 20 / 326

20
en
Lubricants for sliding surfaces
For lubrication and servicing of sliding surfaces, we recommend using plain, acid-
free, watertight, brand plain bearing greases.
Troubleshooting (Design RSG Ex (**)).
Warranty.
The warranty for the product is valid in accordance with the legal regulations in the
country where it is marketed.
Application Tools and Accessories.
Circular saw blades
3 2 3
3
I
3
Lubricating point Lubricant or operating material
2 (gearbox) See Table: Lubricating oil for tool spin-
dle head
3 (sliding surfaces and moving threads) Plain bearing grease
Malfunction Possible Cause Corrective Action
Motor and application tool fail Very low ambient temperatures Use FEIN gear oil for low temperatures
Blunt or dull application tool Replace application tool
No mains voltage Check mains supply and switchgear
Incorrect mains voltage Check mains supply data
Feed rate too fast or too high material removal during
one run Adapt gearing and/or reduce immersion depth
Oil loss at gearbox Locate leakage and correct cause – Refill oil
Excessive temperature increase in motor Reactivate switchgear assembly 3 07 02 041 01 4
Defective drive sprocket Damaged chain piece Replace chain piece
Chain incorrectly connected Check connection points and correct
Chain pin only partially inserted Fully insert chain pin
Faulty cutting process Incorrect alignment of pipe milling machine and chain see section "Preliminary work on the pipe milling
machine (see Fig. A)." on page 16 and section "Clamp-
ing the pipe milling machine on the pipe." on page 16
Guide shaft not eccentric Readjust the running accuracy, see section "Adjusting
the running accuracy". on page 17
Blunt or dull application tool Replace application tool
Inclined or vertically seated pipe or pipe out of round Use track guidance device, see section "Clamping the
pipe milling machine on the pipe." on page 16 and sec-
tion "Track guidance" on page 19
Application tool overloaded Adapt gearing and/or reduce immersion depth
Reduced or ineffective machine function No mains voltage Check mains supply and switchgear
Switch not switched on Check switch
Clutch slips Adjust gearing or have the response torque of the
clutch adjusted at the FEIN factory.
Heavy vibrations Feed rate too fast Adjust gearing
Application tool immersed too deep Retract application tool setting
Clamping lever ( 11 ) not tightened Tighten clamping lever
Chain loose Check chain tension
Blunt or dull application tool Replace application tool
1 2 3
Form 1 , HSS, for gear type:
A, B - For machining steel pipes
Ø Width Weight Number
of teeth Max. cut-
ting depth Order number
(mm) (mm) (kg) (mm)
160 4 0.5 50 25 6 35 02 022 00 6
180 4 0.7 60 35 6 35 02 037 00 8
200 4 0.9 64 45 6 35 02 053 00 7
220 4 1.3 70 55 6 35 02 041 00 1
Form 2 , HSS, for gear type:
B - For machining cast iron pipes
Ø Width Weight Number
of teeth Max. cut-
ting depth Order number
(mm) (mm) (kg) (mm)
160 4 0.5 40 25 6 35 02 050 00 1
180 4 0.7 46 35 6 35 02 098 00 0
200 4 0.6 50 45 6 35 02 099 00 4