Step-by-Step Assembly:
Page 10
Replacing the Fuse:
Turn the power switch to “O” off.
Remove the power cord.
Unscrew the fuse group (1) from the base (2) with a
flathead screwdriver.
Install a T250V, 3.15A fuse.
C-Mount Assembly:
Loosen the trinocular head set screw (1) and remove
the trinocular port dust cap (2).
Remove any dust cover caps from the c-mount (3).
Insert the c-mount into the trinocular port as image
shows at right and tighten the set screw (1).
Loosen the c-mount set screw (4).
Connect the camera to the c-mount threads (5) and
tighten the set screw.
When the eyepieces are in focus, adjust the focus on
the c-mount with an allen key to parfocal the camera
with the eyepieces.
Phase Contrast Slider Assembly:
Insert the slider (1) from left to right with the
inscription facing up.
Each hole in the phase slider has a corresponding
position.
When using phase contrast make sure the
adjustment ring on the aperture diaphragm (2) is set
to “PH”.
Each phase objective should be used with the
corresponding phase ring diaphragm (for example
10xPH with 10x ring).
The phase slider is pre-centered.
Darkfield Slider Assembly:
Insert the slider (1) from left to right with the
inscription facing up.
When using darkfield adjust the aperture diaphragm
to an open position.
The darkfield ring diaphragm adjustment (1) is
located on the left side of the slider.
