10
en
en
Original Instructions.
Symbols, abbreviations and terms used.
The symbols in the Instruction Manual and on the machine shall aide in directing your attention to possible hazardous
situations when working with this machine.
Symbol, character Explanation
Do not touch the rotating parts of the machine.
Observe the instructions in the text or graphic opposite!
Make sure to read the enclosed documents such as the Instruction Manual and the General Safety
Instructions.
Before commencing this working step, pull the mains plug out of the socket. Otherwise there
may be danger of injury caused by unintentional starting of the machine.
Use eye protection during operation.
Use ear protection during operation.
Use a dust mask during operation.
Use protective gloves during operation.
Danger warning
These locations can become hot.
Confirms the conformity of the power tool with the directives of the European Community.
Worn out machine and other electrotechnical and electrical products should be sorted sepa-
rately for environmental-friendly recycling.
3~
Mains supply: three-phase alternating current
Switching on
Switching off
Rotation direction
/I
Product with basic insulation plus additional insulation on touchable, conductive parts connected
to the protective conductor.
(**)
may contain numbers and letters
Character
Unit of measure-
ment, international
Unit of measure-
ment, national
Explanation
v
0
m/s
m/s
Sanding-belt speed
n
/min, min
-1
, rpm,
r/min
rpm
No-load speed
P
1
W
W
Power input
U
V
V
Rated voltage
f
Hz
Hz
Frequency
l
1
mm
mm
Sanding-belt length
l
2
mm
mm
Sanding-belt width
kg
kg
Weight according to EPTA-Procedure 01
OBJ_BUCH-0000000325-001.book Page 10 Tuesday, September 11, 2018 11:15 AM
