21
en
Notes on sanding.
Press the power tool with the sanding sheet
briefly and firmly against a flat surface and
briefly switch the power tool on. This pro-
vides for good adhesion and prevents pre-
mature wear.
When only one tip or corner of the sanding
sheet is worn, it can be removed again and
reattached, turned by 120°.
Work with the entire surface of the sanding
plate, not only with the tip.
When sanding with small triangle sanding
plates, select a high oscillating frequency
(electronics level 4 – 6); when sanding with
the round sanding plate and the large trian-
gle sanding plate, select a moderate oscillat-
ing frequency (max. electronics level 4).
Sand with continuous motion applying
moderate pressure. Applying excessive
pressure does not increase the rate of
removal, it only wears off the sanding sheet
faster.
Notes on sawing.
Select a high oscillating frequency. Round
saw blades can be released and clamped off-
set again, to allow for uniform wearing off.
Notes on scraping.
Select a moderate to high oscillating fre-
quency.
