Feig Electronic PAN MOBILE ID smartSCANNDY, Руководство пользователя, Страница: 8 / 24

IDENTIFICATION
ID smartSCANNDY 4 Product Description
Page 8 of 24
4 Product Description
Product Description
Fig. 1: ID smartSCANNDY top view
Label Description Function
1 Left LED (green)
Left LED (red) Green LED: Lights up green when the smartSCANNDY is turned ON.
When the battery level is empty, it flashes every 2 sec.
(Further function can be user defined with the programming interface.)
Red LED: Lights up red if connected to a battery charger (USB or power
adapter).
2 Right LED (yellow)
Right LED (blue) Yellow LED: Lights up yellow if a barcode or RFID tag was read
successfully. Is flashing yellow (500ms) when connected to USB (USB
memory stick mode). (Further function can be user defined with the
programming interface.)
Blue LED: Lights up blue if Bluetooth connection is established. (Further
function can be user defined with the programming interface.)
3 Key 1
(Trigger barcode or RFID
reader) Default: Triggers the barcode and/or the RFID reader. (This function can be
configured by using Master Setup or with the programming interface.)
4 Key 2
(Custom) (This function can be configured by using Master Setup or with the
programming interface.)
5 Key Power ON/OFF Default: ON/OFF button
Device OFF: press this button to switch ON
Device ON: press this button to switch OFF
(This function can be configured by using Master Setup or with the
programming interface.)
6 Configuration Mode Alternative Configuration Mode
Follow the instructions below to set the Configuration Mode:
1. Switch off the device.
2. Press and hold key 2 and key Power ON/OFF until you hear a beep
(this may take a few seconds).
3. Connect the device to a computer via USB.
4. The device will be mounted as removable drive “SCANNDY”.
5. Open the file “config.ini” or use the Universal Configurator to modify the
settings.