OBID
i-scan
®
UHF
Manual
ID ISC.LRU3000/3500
FEIG ELECTRONIC GmbH
Page 188 of 193
H90202-7e-ID-B.docx
ANNEX C: Index of Status Bytes
Hex-value
General
0x00
OK:
Data / parameters have been read or stored without error
Control command has been executed
0x0F
Busy:
The Reader is in full activity. The host should repeat the command later.
0xF1
Hardware Warning:
•
RFC works not properly
•
Communication link between ACC and RFC works not properly
•
RF Decoder (FPGA) or Hardware Filter works not properly
0xF2
Initialization Warning
•
ACC is initialized partly or completely with default values and Host Mode may be enabled
Hex-value
Transponder Status
0x01
No Transponder:
No Transponder is located within the detection field of the Reader.
The Transponder in the detection field has been switched to mute .
The communication between Reader and Transponder has been interfered and the Reader is not able to
read the Transponder anymore.
0x02
Data False:
CRC16 data error on received data.
0x03
Write-Error:
Negative plausibility check of the written data:
Attempt to write on a read-only area
Too much distance between Transponder and Reader antenna.
Attempt to write in a noisy area.
0x04
Address-Error:
The required data are outside of the logical or physical Transponder-address area:
The address is beyond the max. address space of the Transponder.
The address is beyond the configured address space of the Transponder.
The reader is not able to handle the requested amount of data
0x05
Wrong Transponder-type:
This command is not applicable at the Transponder:
A special command is not applicable to the Transponder.
