Identifikationssystem OBID ®
Installation Manual Shield antenna
FEIG ELECTRONIC GmbH
M00102-0e-ID.doc
page 3 of 8
1.4 Ranges
Dependent on the environmental conditions, the following reader ranges can be obtained, if the
orientation of the transponder to the antenna is parallel and central.
ID ANTRW.8060-A
transponder type
range
ID DTK.A
660 mm
ID CTK.B
700 mm
ID ANTRW.5040-A
transponder type
range
ID DTK.A
560 mm
ID CTK.B
570 mm
1.5 Connecting the shield antenna to the ID AT-A
The connection of the shield antenna is executed via the automatic antenna tuner ID AT-A at the
terminals X2. In order to do this, lead the cable through the corresponding attachment screw.
Eventually replace the cable screw-joint for ribbon cables by a screw-joint for round cables.
Picture 1.5-1 Connecting plan of a shield antenna
1.6 Checking and debugging
If the automatic antenna tuner doesn't tune correctly, cabling errors easily can be detected by means
of an Ohm-Meter. For doing this, please observe the corresponding specifications for resistors in
chapter "Technical data" and the installation manual of the ID AT-A.
