12
W
ar
n
in
g s
ig
n
al
Around the positions: front, rear, right and left, a vibration signal
moves quickly alternately left and right at the same time. The
interpretation of the signal depends on the context of its
occurrence.
During a navigation it means poor GPS reception or poor
accuracy of direction indication. The direction indication may
be distorted and therefore incorrect. Please pay attention to
your surroundings when navigating!
When clicking on the Favorite button on the belt: If no
favorite has been set or if there is no connection to the
smartphone.
Abortion of the calibration procedure
Sw
it
ch
-o
ff
si
gn
al
4 units vibrate simultaneously (front, rear, sides) with decreasing
intensity until the belt is completely off.
B
at
ter
y c
h
ar
ge
level
Depending on the charge level, a vibration signal moves clockwise
around the abdomen completely or partially and ends with a
double vibration pulse. e.g. full charge: signal moves completely
around the abdomen, half charge: signal moves only up to half
around the abdomen, etc.
Care instructions
Your naviBelt is a high-tech device and should be handled with care. Follow the care
instructions to ensure maximum service life.
Cleaning:
Textile outer cover is washable: Wash the outer cover of the belt occasionally if
you use the naviBelt frequently.
o
To do this, separate the textile outer cover from the technical tube
together with the control unit! Open the textile outer cover using the
Velcro fastener on the inside. Fold the ends of the outer cover and release
the technical tube, which is attached to the outer cover with Velcro.
Carefully pull the control unit from the inside out of the pocket.
o
Hand wash or gentle wash at 30°C without spinning
o
wash without fabric softener
