Federal SNR48, Инструкция по установке и эксплуатации

Страница: 17 / 44

Series ’9 0 Refrigerated Bakery Page 17
Interior Cleaning
1. Remove rear doors from track by lifting door upward until the bottom of the door
clears the lower door track and then outward. Remove the inner door in the same
manner.
2. Lift up the front glass to the fully open position.
3. Remove all shelves from the case.
4. Unplug the shelf lights and lift the shelf support assembly out of the shelf standard slots.
5. Remove the two (2) thumb screws holding the shelf standard to the side wall and take
the shelf standard out of the case.
6. Lift the display pans up and take them out of the case.
7. Clean the entire interior of the case using warm soapy water. Wipe off all soapy water
with a damp cloth and allow to dry.
Note: Depending on the amount and spillage of foreign material, some fasteners may have to
be removed and parts disassembled to allow proper cleaning of the unit.
8.
Clean all shelves, shelf support assemblies, shelf standards, and display pans using
warm soapy water and a brush. Rinse thoroughly and allow to dry.
9. Clean all foreign material from inner and outer rear door tracks using warm soapy
water and a brush. Apply a light film of lubricant, such as PAM, to make the doors
operate smoother.
10. Clean both sides of the doors and interior of the front glass using any common window
cleaner.
11. Reassemble the case in reverse order starting with step 6.
Exterior Cleaning
1. Clean the front glass using any common window cleaner.
2. The exterior surfaces should be wiped down using any ammoniated cleansers or warm
soapy water.
Plastic exterior surfaces can be cleaned with any ammoniated household cleaner. Stains
can be removed by scrubbing with TRIALENE Soap, ETHYL CELLOSOLVE,
CARBONA, or similar solvent base cleaning fluids. The surfaces must be thoroughly rinsed
with warm water after using solvent based cleaners.