2561765A
REV. A 1101
Printed in U.S.A.
INSTRUCTION SHEET
FOR
STREETHAWK® LED LOWER LEVEL RETROFIT KIT
SAFETY MESSAGE TO INSTALLERS AND USERS
People’s lives depend on your safe installation of
our products. It is important to read, understand and
follow all instructions shipped with the products. In
addition, listed below are some other important
safety instructions and precautions you should
follow:
•
To properly install this light, you must
have a good understanding of automotive
systems, along with proficiency in the
installation and use of safety warning
equipment.
•
You should frequently inspect the light to
ensure that it is operating properly and
that it is securely attached to the vehicle.
•
This product contains high intensity LED
devices. To prevent eye damage, DO NOT
stare into the light beam at close range.
•
The light should be frequently inspected
to ensure that it is operating properly and
that it is securely attached to the vehicle.
•
File these instructions in a safe place and
refer to them when maintaining and/or
reinstalling the product.
Failure to follow all safety precautions and
instructions may result in property damage, serious
injury, or death to you or others.
A. GENERAL.
WARNING
This unit is designed for use in the lower level
of the Streethawk lightbar only. Do not install
in any other lightbar.
This device is a retrofit LED light head for use in
the Federal Signal Streethawk lightbar. It is designed
to operate on a 12.8 VDC, negative ground system. It
is to be used with flashers designed for use with LED
lights, such as the Federal Signal Intelli-Flash™
Model 650200 Flasher or the Federal Signal FA3C
Flasher. The unit is comprised of an aluminum
mounting bracket with three LED modules installed,
a PCB board with heat sink attached, and a wire
harness.
B. KIT CONTENTS LIST .
Qty.
Description
Part No.
6
Cable Tie
150A109
2
Screw, Hex Hd., Type B
7011A122-08
1
Red female 1/4" tab connector
224A216-01
1
Red male 1/4" tab connector
224A217-01
1
Red #10 ring lug
224A200-05
C. INSTALLATION.
1.
To install lower level LED modules when
using the Intelli-Flash Model 650200 flasher, proceed
as follows:
a.
Remove the domes.
b.
Move or remove any upper level lamp
assemblies that interfere with lower level lamp or
harness access. Rotate rotator worm gears by hand if
mechanism blocks screw access.
c.
Service one lamp at a time to avoid
wiring mix-ups. Cut wire ties as needed for connector
access. Remove screws securing lamp to be replaced.
Trace leads back to harness connector and ground
screw and remove. Retain brass spacers and/or
washers for ground screw. Retighten the ground
screw after the old lamp ground connections to the
screw are removed.
d.
Place the LED module into position
(electrical connector is at the top) and install the
screws. Take care not to strip the threads in the light
bar base.
e.
Route leads to avoid interference, espe-
cially with hot or rotating parts. Plug the LED
module’s red power lead into the existing harness
connector. Make a note of the wire color. Route the
ground wire through the bar to the end where the
main cable enters the bar. Do not terminate at this
time.
f.
Repeat for other lamp(s), and then
remove existing flashers and flasher harnesses.
g.
Locate the Intelli-Flash flasher near the
terminal strip and secure.
