Exploring the Interface
30
SmartSiren Platinum Series
Horn Ring
The
Horn Ring
button is for the horn-ring transfer circuit connected through pins 2 and 8 on the 12- pin
connector on the SmartSiren Platinum siren amplifier. The default setting for the slide switch is to
transfer the horn ring activation of the siren in
Slide Switch 2
and
3
. Each press of the horn button on
the steering wheel steps through the
Siren Function
selected for the
Horn Ring
button. In addition,
Slide Switch 2
is configured as
Siren Dependent Enabled
.
Pins 2 and 8 (gray) in the 12-pin
connector on the back of the
SmartSiren Platinum Siren Amplifier
P
ARK
DISABLE
RADIO
RING
SPKR
P
ARK
DISABLE
RADIO
HORN
SPKR
-
+
-
+
Pin 12
Pin 6
CONTROLS
File Transfer Status Panes
The
File Transfer Status
Panes at the bottom of the SmartSiren Platinum 3000 Configuration Software
window displays information about the transfer progress of configuration files between the control pad
and your computer.
Uploading Configuration Files
The file upload process begins when you select
Program Control Head
from the
System
menu.
The uploaded file replaces the file in the flash memory of the control pad. The file is ready to control
the configured devices in the Convergence Network. For additional menu commands, see the table
on page 32.
Downloading Configuration Files
The file download process begins when you select
Read Control Pad Configuration
from the
System
menu. The command transfers a configuration file from the control pad to your computer for
editing.
The next chapters describe how to configure the control pad using each pane in the
Device
Selection Module
. For an overall view of the default settings, see the table on page 115.
Содержание SmartSiren Platinum Series
Страница 1: ...Control Pad Configuration Software Manual 2562418C REV C 411 Printed in U S A...
Страница 6: ...6...