2561235B
REV. B 798
Printed in U.S.A.
INSTRUCTION SHEET
FOR
GRILLE LIGHT MODEL GS2
SAFETY MESSAGE TO INSTALLERS AND USERS
People’s lives depend on your safe installation of
our products. It is important to read, understand and
follow all instructions shipped with the products. In
addition, listed below are some other important
safety instructions and precautions you should
follow:
•
To properly install this light: you must
have a good understanding of automotive
electrical procedures and systems, along
with proficiency in the installation and
use of safety warning equipment.
•
DO NOT install equipment or route
wiring in the deployment path of an air
bag.
•
When drilling into a vehicle structure, be
sure that both sides of the surface are
clear of anything that could be damaged.
•
In order for the light to function properly,
a separate ground connection must be
made. If practical, it should be connected
to the negative battery terminal. At a
minimum, it may be attached to a solid
metal body or chassis part that will
provide an effective ground path as long
as the light system is to be used.
•
Locate light control so the VEHICLE and
CONTROL can be operated safely under
all driving conditions.
•
Do not attempt to activate or deactivate
light control while driving in a hazardous
situation.
•
You should frequently inspect the light to
ensure that it is operating properly and
that it is securely attached to the vehicle.
•
File these instructions in a safe place and
refer to them when maintaining and/or
reinstalling the product.
Failure to follow all safety precautions and
instructions may result in property damage, serious
injury, or death to you or others.
A. GENERAL.
The Model GS2 is a high intensity, wide angle,
directional strobe light head intended for use on a
vehicle’s exterior. It is designed for use with any of
Federal’s strobe power supplies (Models SPS2/SPS2P,
SPS4/SPS4J/SPS4P, and SPS6J). The unit is supplied
with an installed 4-foot cable and mounting brackets
for various mounting arrangements.
B. KIT CONTENTS LIST.
Qty.
Description
1
Nut, Hex, 8mm, SS
1
Washer, Flat, 8mm, SS
1
Washer, Split, 8mm, SS
1
Screw, Hex Hd., 8 x 25mm
1
Connector, Plug
3
Terminals, Socket
1
Block, Pin
1
Nut, Plastic
1
Washer, Rubber
2
Bracket, Plastic
1
Screw, Allen Hd., 8 x 45mm
1
Nut, Stop, Hex, 8mm
6
Terminals, Socket (Red)
C. INSTALLATION.
WARNING
This product is intended for supplemental
warning and for use in conjunction with an
approved primary warning light system. This
strobe head can be powered by several types
of strobe power supplies. Consult local codes
and regulations to determine if the power
supply/strobe head combination complies.
NOTE
For maximum coverage and effectiveness, the
light assembly should be mounted in a
horizontal orientation.
1.
Metal Bracket Mounting.
To install the unit using the installed metal
bracket, proceed as follows:
a.
Determine the desired mounting location.
Scribe drill position marks on the mounting surface
