INF-TN1FSH-E
- 125 -
7.10. Status Output Setting
Click the “STATUS” button on the Menu screen, and the following screen appears.
Fig. 19 <Status output setting screen>
To select an item to be set or read, set the relevant check box to ON (
"
). Not to select (or to reset the selection), set
the relevant check box to OFF (
#
).
[Setting].......................................... Sends the setting of the selected item (check box set to ON (
"
)), reflecting the
response value on the setting.
[READ] .......................................... Reads the setting of the selected item (check box set to ON (
"
)), reflecting the
response value on the setting.
[Save] ............................................. Reflects the setting sent by pressing the [Setting] button on the flowmeter flow
transmitter.
[Check ON/OFF]............................ Set the check box to ON to select all the items (to set all the check boxes to ON
(
"
)). Set the check box to OFF (
#
) to release the selection of all the items (to
set all the check boxes to OFF. (
#
))
Table 12 <Status output setting>
Item Content
OUTPUT DO 1
Select from NOT USED, SIGNAL ERROR, F: TOTAL PULSE, R: TOTAL
PULSE, F: TOTAL SW, R: TOTAL SW, F: TOTAL OVERFLOW, R: TOTAL
OVERFLOW, FLOW SW HIGH, FLOW SW LOW, FULL SCALE 2, AO
RANGE OVER, PULSE RANGE OVER, R: FLOW DIRECTION and DEVICE
ERROR.
OUTPUT DO 2
Same as above
OUTPUT DO 3
Same as above
MODE DO 1
Select either NORMAL or REVERSE.
MODE DO 2
Same as above
MODE DO 3
Same as above
