FDC ENIGMA II SLIMLINE, Руководство пользователя, Страница: 9 / 24

LT4934 (1:01/08)
9
ENIGMA II SLIMLINE Users Instructions
SECTION FOUR Cleaning
Warning: - Before you clean any part of the appliance ensure that the appliance is turned off
and cool.
CLEANING: DECORATIVE TRIM
• The finish of the trim is coated with a high temperature lacquer, it can be wiped with a soft,
clean, dry, cloth only.
• The trim should be removed for cleaning. The fret should be removed before removing the
trim, which is held in place by four magnets.
CLEANING: BLACK PAINTED or CHROME EFFECT SURFACES
• These surfaces should be dusted regularly and any marks removed with a soft cloth.
• Abrasive or chemical cleaner should never be used.
CLEANING COALS, PEBBLES and CERAMIC PARTS
Important: -
Refer to the ‘Heath & Safety Notice located on page 3 of this
booklet before cleaning or replacing any refractory material.
• The coals & pebbles are delicate and they should be handled with great care.
• The loose coals & pebbles may be removed for cleaning. They can be brushed very gently
with a soft brush to remove dust or any deposits.
• Care should be taken to avoid contact with the refractory lining; this is a delicate surface and
should
not be wiped or rubbed.
• A vacuum cleaner may only be used after all the loose coals have been removed.
SECTION FIVE General Points
Like all appliances incorporating an aerated burner a Low frequency noise may be heard,
particularly on the Low setting, this is quite normal and does not affect the operation of the
appliance.
It is advised that the ENIGMA II SLIMLINE OR III Lo fire is serviced annually this is more likely
to provide trouble-free operation.
It is important that: -
•
The chimney or flue is checked annually to ensure clearance of combustion products.
• The fire does not normally require purpose-built ventilation but if for any special reason
purpose-built ventilation is provided it should be checked periodically to ensure freedom from
obstruction.
• Any debris from the chimney or flue should be removed. The fire should be allowed to cool
for three to four hours before it is removed.
• Rubbish must not be thrown onto the coal bed under any circumstances.
• The cast fire front must be positioned in front of the fire whilst it is burning
The only user removable parts are: -
• Cast fret
• Loose fuel bed components
• Decorative effect trim