FDC ENIGMA II SLIMLINE, Руководство пользователя, Страница: 4 / 24

LT4934 (1:01/08)
4
ENIGMA II SLIMLINE Users Instructions
SECTION ONE Important Information Continued
INTRODUCTION
The ENIGMA II SLIMLINE incorporates a single gas control, which selects ignition pilot, low or
high settings. It is operated via a control knob located behind the ash pan cover.
The appliance incorporates a safety device in the form of an Oxygen Depletion System, which
constantly monitors the oxygen in the room and will cause the fire to switch off if the oxygen
level reduces, for instance due to insufficient ventilation or a blocked flue.
If this regularly occurs do not attempt to relight the appliance until a qualified engineer has
checked it, the problem may not be due to lack of air or a defective flue.
The pilot can be left on or the pilot can be extinguished and relit each time the fire is used.
A fire front (fret) must be used with this appliance.
SECTION TWO Operating the Appliance
The appliance Control Knob is positioned behind the ash tray cover.
The full lighting procedure for the appliance is as follows: -
a. Remove ash pan cover.
b. Push knob in as far as possible on gas control.
c. Turn knob anti-clockwise until a click is heard. The knob will stop at the position marked
' '
and a flash should be seen at the left-hand side of the burner. At the same time the pilot
flame should light. KEEP THE KNOB PRESSED IN FOR 20 SECONDS. Should the pilot
fail to light, turn the control knob clockwise to the
' '
position, and repeat the procedure.
d. After lighting the pilot flame the control knob should be allowed to spring out slightly. This
will allow you to turn the knob further anti-clockwise to the position marked
' '
. The pilot
flame should then ignite the main burner.
e. It is possible to adjust the height of the flames by turning the control knob between the
positions marked
' '
and
' '
. Note that the knob 'latches' in position at either end of this
movement and must be pushed in slightly before it can be turned.
f. To turn the burner off, depress the knob slightly and turn it to the
' '
position.
g. To completely extinguish the fire, depress the knob slightly and turn to
' '
the position.
h. Replace ash pan cover.
Note: - If the ignition fails the pilot can be lit with a taper or a match held at the pilot head.
Remove fret for access and replace after lighting.
If the fire is extinguished for any reason wait 3 minutes before relighting.