K3590-FBIIV1 6/01
REMOTE KEYPADS
Omni
®
-KP & Omni
®
-LCD
(
Omni-LCD is not available in the U.S.
)
INSTALLATION AND SETUP GUIDE
Keypad Features
Omni-KP
Fixed-Word
Omni-LCD
2-Line Alpha
Backlit Display
YES
YES
Built-in Sounder
Piezo
Speaker
The Omni
®
-KP and Omni
®
-LCD are addressable Remote
Keypads designed for use with FBII Omni Series control
panels. Addresses are set via the keypad keys.
The keys on the keypads are continuously backlit for
convenience.
KEYPAD DISPLAYS AND LEDS
The keypads have the following display features:
Model
Fixed
Word
Display
2-line
Alpha
Display
2-digit
Zone
Identifier
Custom
Zone
Descriptors
Omni-KP
X
X
Omni-LCD X
X
The following table shows the LEDs and their functions:
LED Function
Red
Lights when the system is armed in any mode
Green
Lights when the system is "ready" to be armed.
WIRING AND INSTALLATION
The keypads can be surface-mounted directly to a drywall, or
to a single- or double-gang electrical box.
1. Remove the case back by sliding the blade of a
screwdriver-between the tab and the case back on each
side of the keypad as shown in lower diagram at right.
2. Route wiring from the control panel through the
opening in the case back.
3. Mount the case back to a wall or electrical box. For wall
mounting of the Omni-KP/LCD in the FR, NL and IT
versions, secure the case back to the wall, being especially
careful to secure the partially knocked-out tamper switch
plunger with its own screw. This assures that separation
of the keypad from its mounting will cause the tamper
switch to activate. Any attempt to pry the keypad open
will also activate the tamper switch in these versions.
4. Wire directly from the keypad’s terminal block to
the terminal block on the control board. Wire functions
are marked next to terminals. Labels are as follows: DI
Data In to Control Panel, - Ground, + Aux. Power Plus,
DO Data Out of Control Panel. See table on next page.
5. Reattach the keypad to its case back.
ARMED
READY
1
4
7
2
5
8
0
3
6
9
#
STAY
BYPASS
INSTANT
CODE
omni-KP-001-V0
Omni-KP w/ Protective Cover Removed
ARMED
READY
1
4
7
2
5
8
0
3
6
9
#
STAY
BYPASS
INSTANT
CODE
omni-LCD-001-V0
Omni-LCD w/ Protective Cover Removed
ARMED
READ
Y
omni-LCD-002-V0
TO SEPARATE TOP COVER
INSERT SCREWDRIVER
AND PUSH HERE
Separating Case Back From Top Cover
