Fayat Dynapac F80W, Руководство по эксплуатации

Страница: 83 / 198

77 F80W
2 1
451162
451163
3
D451164
3
3
D451165
1
4
5
5
2
2
OPERATING MANUAL
2.5.5 Mounting of screed reduction plates
By mounting the screed reduction plates the material paving
with is changed.
The paving width in the standard model of the machine is:
• Minimum paving width without reduction plates 800 mm
(31.5 in)
• Maximum paving width without reduction plates: 1,300 mm
(51.2 in)
Paving width with reduction plates is:
• Minimum paving width with reduction plates: 250 mm
(9.8 in)
• Maximum paving width with reduction plates: 750 mm
(29.5 in)
When mounting screed reduction plate set, the augers must be
dismounted from the machine.
Screed reduction plate set:
1 Screed reduction plate – left
2 Screed reduction plate – right
3 Protective cases of auger shaft
Procedure of mounting of screed reduction plates
• The procedure of mounting is the same for the left and right
screed reduction plate.
• Park the machine on a flat solid surface.
• Start the engine.
• Lift the screed of the machine to the transportation position
and secure it.
• Extend the screed on the left and right side of the machine
to the maximum position.
• Turn off the engine and the battery disconnecter.
• Mount the paving reduction plates with the shaped edge (1)
on the machine in the forward machine travel.
• Insert pins (2) on both sides of the screed to the holes (3) on
the screed end gate (4).
• Secure the pins using a split pin (5).
Mount the paving reduction plates on the machine which
is parked on parked on a flat and solid surface.
When mounting reduction plates, the engine and the
battery disconnecter must be switched off.
Risk of burn injury when installing the screed reduction
plates.
When mounting reduction plates, wear protective
equipment.
When mounting screed reduction plate set, the augers
must be dismounted from the machine.