Fayat Dynapac F80W, Руководство по эксплуатации

Страница: 60 / 198

54 F80W
2.2 Preservation and storage
2.2.3 Preservation and storage of the machine
for a period over 2 months
Before storing the machine, clean and wash the whole machine.
Before putting the machine out of operation, start the machine
to warm operating fluids up to the operating temperatures.
Then refill the operating fluids up to the levels specified in this
Operating Manual.
Before preserving and storing, clean the machine from coarse
impurities and wash.
Wash the machine only in areas with intercepting traps
to intercept the contaminated water and detergents.
Park the machine on a flat solid surface in a safe area
when there is no danger of damage to the machine by
a natural disaster, e.g. landslides, floods and fire.
The following tasks must be performed first on the machine:
• the machine hopper must be closed and locked,
• the machine screed must be put horizontally on a flat and
solid surface,
• protective covers of the individual instruments and machine
covers must be locked,
• the protective roof of the machine must be adjusted in the
lowest working position,
• if the machine is equipped with a gas bottle, the gas bottle
must be removed from the machine and stored in a special
area.
Then it is recommended to perform the following tasks:
• repair damaged paintwork,
• service lubrication points according to instructions stated in
the manual,
• check the pressure in tyres if the machine is equipped with
wheels; protect the tyres from direct sunlight,
• check that the water tanks are drained if they are on the ma-
chine,
• check that the coolant has the desired antifreeze properties,
• remove the batteries from the machine; recharge them ac-
cording to instructions of the manufacturer and store them
in special areas,
• apply chemical preservatives on chromium-plated surfaces
of piston-rods,
• we recommend you to protect the machine from corrosion
by applying a chemical preservative, particularly in areas
where corrosion can occur,
• protect all rubber parts of the machine with chemical pre-
servatives,
• seal the holes, through which atmospheric precipitations
can penetrate in internal cavities of parts of the individual
components of the machine,
• Protect the head lamps and side rear-view mirrors with
chemical preservatives,
• protect other elements of the external electrical installation
using a special spray,
• preserve the engine according to instructions of the manu-
facturer of the engine and mark visibly that the machine has
been preserved.
Never start the engine of the machine during storage!
A machine stored for a time interval longer than
2 months must be regularly inspected according to the
following instructions, every 6 months in mild climatic
conditions, every 3 months in tropical, cold, arctic and
seaside conditions.
In order to protect components of a machine stored for
a time interval longer than 2 months, during the regu-
lar inspections remove the chemical preservatives and
put the machine into operation to rebuild the oil film in
various hydraulic and mechanical parts of the machine.
If you want to keep storing the machine in the long term,
complete the preservation and storage procedure for
the time interval longer than 2 months.