Fayat Dynapac F80W, Руководство по эксплуатации

Страница: 159 / 198

153 F80W
D451113
3
2
D451114
6
5
4
D451126A
1
451194A
MIN MAX
3
MAINTENANCE MANUAL
Every 250 hours of operation (every 3 months)
3.6.17 Engine oil replacement
Change the engine oil when the machine is parked on a flat and
solid surface, the engine and the battery disconnector are off
and the gas bottle is closed.
Engine oil replacement procedure:
• Open the engine bonnet (1).
• Remove the engine oil dipstick gauge (3).
• Remove the hose (4) from the holder (5).
• Dismount the plug (6) and let oil drain to a ready container
with a minimum capacity of 2 l (0.53 US gal).
• Check the plug seal (6) and replace it, if damaged.
• Mount the plug (6).
• Connect the hose (4) to the holder (5).
• Add engine oil through the engine oil filler neck (2).
• The total oil volume is 1.8 l (0.50 gal US).
• Check the engine oil level on the oil dipstick gauge (3).
• The correct engine oil level must be within the MIN and MAX
marks on the oil dipstick gauge (3).
• Close the engine bonnet (1).
• After you change the oil, start the engine and let it run at
a higher idle speed for 2 – 3 minutes.
• Stop the engine and wait for about 3 minutes until the oil
runs into the crankcase, then check the oil level again.
Change the engine oil when the machine is parked on a
flat and solid surface, the engine and the battery discon-
nector are off and the gas bottle is closed.
Wear the prescribed personal protective equipment
when replacing the oil in the engine.
There is a risk of burns from the hot parts of the engine
and the engine oil.
The oil level must not exceed the MAX level line on the oil
dipstick gauge.
Catch the drained oil and do not let it soak into the
ground.
Dispose of the engine oil according to the applicable na-
tional regulations.