Fayat DYNAPAC DRP20D, Инструкция по эксплуатации, Страница: 74 / 102

7.
CAUTION!
Danger of eye injuries caused by particles
flying around!
– Wear your personal protective equipment
(safety gloves, protective working
clothes, goggles).
Use compressed air to blow the oil filter out from inside to
outside.
8. Check the seal ring (2) for damage, change if necessary.
9. Slightly oil the seal rings (1) and (2).
10. Insert the oil filter (2) into the housing and press it against the
end stop.
11. Before tightening the screw (1) make sure that the tensioning
springs touch the oil filter with both ends.
12. Tighten the screw.
13. Fill in new engine oil.
14. After a short test run check the oil level on the dipstick; if nec-
essary, top up to the top dipstick mark.
15. Check oil filter and drain plug for leaks.
16. Dispose of oil in an environmentally friendly way.
8.8.2 Changing the oil in the exciter housing
NOTICE!
Components may get damaged!
– Use only oil of the permitted specification
Ä
Chapter 8.4 ‘List of fuels and lubricants’
on page 67 .
Fig. 58
Fig. 59
Filling in engine oil
Fig. 60
Final work
Maintenance – Annually
DRP20D 74