Fat Shark
6
Setup
The ATTV6 has many features that can be customized to the individual pilot. This level of
personalization requires some interaction to properly set it up for each individual. The following
topics are items to be aware of while tuning your ATTV6 to you.
Input Power:
The ATTV6 is shipped in Legacy Mode. If you connect a 7-13V (2S or 3S) power source to the
power port the ATTV6 will automatically power on and it will power off when the source is
removed. With a short press, the
Power Button
will turn on and off the fan while in this mode. If
you hold the button, the ATTV6 will continuously beep to remind you the headset is in Legacy
Mode and the goggles will not power down.
If you want, you can change the input power to use the Power Button to turn on and off the
headset. To do this, you need to remove the Expansion Bay door and move the power mode
jumper from Legacy Mode to Button Mode as show below.
Power Port
(7-13V)
AV Input/
Output
Assistant
module
Primary
module
Power Mode
Jumper Pins
Legacy Mode
Jumper
Location
Button Mode
Jumper
Location
