3. Printer Operation
3.1 Commission
（
For F530 / F530Plus
）
Printer needs to be filled with ink and exhaust air before use.
1. Open the lower cabin door, pull out the ink system, and fill 750ml of ink (one cartridge)
into the mixer tank with a beaker in the order of
A. B.*
C. D., as shown in figure:
2. According to the label, install the correct ink and make-up cartridge to the correct
position, push the ink system into the cabin and close the lower cabin door .
3. Connect the printer to an appropriate power source and power on the printer .
4. Enter the
INK SYSTEM
menu and perform
E) Exhaust Air
program to complete ink
way priming. Screen prompt will advise when complete.
NOTE: Ink will come from the
gutter, place a catcher under the printhead.
5. Clean the printhead.
Page
14
C
. Remove the lid of the condenser
(Installed back after filling)
A. Remove the exhaust
air plug
！
！
D
. Use a beaker to fill 750ml
ink from the condenser
B. The exhaust air switch must
be turned on before use.
* During normal use of the printer, the exhaust vent plug
A
needs to be removed, and the exhaust
air switch
B
needs to be opened , otherwise it will cause printer failure.
