Fast 9553P, Руководство пользователя

Страница: 80 / 87

PREPARING FOR STORAGE
PREPARING FOR STORAGE 3PT Sprayer 9553P / 9573P Page 80
PREPARING FOR STORAGE
CAUTION: Store the unit in an area
away from human activity. Do not
permit children to play on or around
the stored Sprayer.
At the end of the season, thoroughly inspect
and prepare the Sprayer for storage. Repair
or replace any worn or damaged
components to prevent any unnecessary
downtime at the beginning of next season.
1. Empty any remaining liquid from
tank. Flush the entire system with
clean freshwater.
2. Open all liquid line connections, the
end cap screen canister, and pump.
Drain all fluids out of the system.
3. Add approximately 38 L (10 Gal.) of
RV antifreeze per 3 m (10 ft.) of boom
to the Main Tank. Add 3.8 L (1 Gal.)
of the same to the Rinse Tank.
4. Flush the system, then pump through
screens, valves, nozzles, check
valves, and orifices/tips.
5. Remove the nozzles from the boom
and store them in a non-freezing
location.
6. Thoroughly wash the machine using
a pressure washer to remove all dirt,
mud, debris, and residue to protect
against corrosion.
7. Lubricate all grease points. Make
sure all grease cavities have been
filled with grease to remove any
water residue from washing.
8. Inspect all hydraulic hoses, couplers,
and fittings. Tighten any loose fittings.
Replace any hose that is damaged or
is separating from the crimped end of
a fitting.
9. Inspect all liquid lines and
connections. Tighten any loose
fittings. Replace any line that is cut,
nicked, or abraded.
10. Touch up all paint nicks and
scratches to prevent rusting.
11. Fold inner and outer wings to the
transport configuration.
12. Install the machine’s storage stands.
13. Move the machine to a storage
position.
14. Select an area that is dry, level, and
free of debris.
15. Place planks under the stands for
added support if required.
16. Unhook Sprayer from tractor.
Removing from Storage
1. Clear the area of bystanders,
especially small children, and remove
foreign objects from the machine and
working area.
2. Attach the tractor to the Sprayer.
3. Remove the machine’s stands.
4. Check:
a. Attach and secure all liquid
lines.
b. Screens and Nozzles.
c. All hardware. Tighten as
required.
d. Tire pressure.
e. All hydraulic lines, fittings,
and connections. Tighten as
required.
5. Lubricate all grease fittings.
6. Replace any defective parts.
7. Add a small amount of liquid to the
tank. Turn the product pump on
momentarily and check that liquid
comes out of each nozzle/injector.
8. Follow the Pre-Operation Checklist
before using.