PLEASE KEEP THIS MANUAL IN A SAFE PLACE FOR FUTURE REFERENCE
Fast Mover Tools Ltd
T: 01582 661993 F: 01582 667100 E: [email protected]
W: www.fastmovertoolsuk.com
areas, use a criss-cross pattern as shown in
Fig. 3
.
Never start or stop the gun whilst it is aimed at the workpiece. Too slow a pass will give a thin and
patchy coat whilst too slow a pass will result in a heavy coat. Apply one coat at a time and observe
manufacturers drying times before applying the next coat or finishing/polishing.
Do not tip the gun more that 45
o
.
Maintenance
- GUN MUST BE SERVICED BY A COMPETENT PERSON
- ALWAYS DISCONNECT FROM AIR SUPPLY BEFORE CLEANING, DISMANTLING OR
SERVICING.
- NEVER IMMERSE GUN IN SOLVENT.
- Pour remaining paint into another container and then clean paint passages and air cap. Spray a
small amount of thinner to clean paint passages. Insufficient cleaning adverse pattern shape and
particles. Clean promptly two-part paint promptly after use.
- Clean other sections of the gun with the brush soaked in thinner or with a waste cloth.
- Always change to air cap, fluid nozzle and needle as a matched set.
- Lightly lube all moving parts with a non-petroleum based lubricant.
Fig. 1
To Spraygun
Whip Hose
Main Airline
Air Filter/Regulator
From Air Source
Quick Release Coupling
Air Fitting
Fig. 2
Uneven finish created by arcing
100 - 250mm
Q
R
B
eg
in
p
as
s
th
en
P
re
ss
T
rig
ge
r
R
el
ea
se
tr
ig
ge
r
th
en
st
op
p
as
s
Keep trigger pressure and passing
speed consistant
Fig. 3
FMT6099_Product Instructions 10/05/2013 10:59 Page 5